Recommended setup
Saw Adapter Hose
Air and dust flow from the saw into the hose. Slide the saw port into the adapter, then press the adapter into the hose. Each joint then steps outward in the direction of flow, so there is no ledge for chips and dust to catch on. This is the default below.
Saw / tool port (upstream)
Vacuum hose (downstream)
Shape & fit
Taper is how much the diameter changes along the engagement length. Fit adjust: positive = looser, negative = tighter. Printers differ, so print a short test first.
How it goes together
Part dimensions
Tips
- Measure, don’t trust labels. Hose and port sizes vary by brand. Use calipers on the inside of anything the adapter plugs into, and the outside of anything that slides into the adapter.
- The taper is centered on your size, so the tip goes in easily and the base presses tight. Flexible hoses grip well; rigid ports may need a bit of Fit adjust.
- Print with 3+ perimeters in PETG or ABS/ASA for durability. Put the hose end flat on the bed.